The latest from Lubinpla
More stories
-
How to replace 2-butoxyethanol in an industrial cleaner
Replace 2-butoxyethanol by matching its coupling, solvency and evaporation jobs, screen glycol ether swaps for flash point and exposure limits and retest.
-
Phosphate Replacements in a Phosphate-Free Alkaline Degreaser
Phosphate-free alkaline degreasers split phosphate's jobs: gluconate binds hardness at high pH, silicate protects aluminum, polycarboxylate disperses soil.
-
Why polyurethane sealant bubbles in the expansion joint
Polyurethane sealant bubbles in a joint from substrate moisture, heat, a punctured backer rod or trapped air. Tell the causes apart and fix the joint.
-
How to make lap shear test coupons that match production
Lap shear test coupons predict a production bond only when the adherend, surface prep, bondline thickness and cure copy the line. How to set them up.
-
How to plan a changeover trial when changing quench oil
Fix cooling curves for used and new oil, run the same reference parts for hardness and distortion, clean the tank, check flash point and set stop rules.
-
Make-up water in a closed loop: when the volume is too high
A closed loop should need almost no make-up water. Set a baseline after filling, then read the meter with inhibitor and conductivity to confirm a leak.
-
Mixing two brands of inhibited glycol in a chiller loop
Only if both makers confirm the same glycol base and compatible inhibitors and a jar mix stays clear. Otherwise drain, flush and refill the chiller loop.
-
Boiler water additives for food-contact steam: 21 CFR 173.310
21 CFR 173.310 allows only listed boiler water additives in food-contact steam, within set limits. See how to check each ingredient and who decides.
-
How to plan a boiler water treatment program changeover
Fix baseline values, sample feedwater, boiler water and condensate more often, set stop signals, then switch dosing in stages and retune blowdown.
-
Switching a boiler to filming amines: risks and failure modes
Switching a boiler to filming amines mostly fails through loosened deposits, overfeed at start-up and testing in the wrong stream. How to spot each one.
Talk to us about your sales team.
Custom plans, custom terms, security reviews and onboarding across teams or branches. Tell us a little about your organization and we will reply with a starting plan.
Contact Sales- 01Start from site data and your documents
Bring in the TDSs, test reports and site records your team already has. Where a case has too little to go on, the agent searches the web for public sources such as manufacturer data and standards.
- 02State the case
Describe the customer's situation in plain words. The agent reads the site's conditions and history, proposes the task that fits, and starts when you say go.
- 03Review the reasoning, step by step
Each step shows what was considered, what the evidence supports and what was ruled out, with the source behind each point. You can carry on, ask for changes or stop.
- 04One document for this customer
The case ends in a document built for that customer: the conclusion, the reasoning, the conditions it depends on and what to do next. Share it through Field Care when you choose.