The latest from Lubinpla
More stories
-
How to plan a gear oil switch trial and its sampling interval
Plan a gear oil switch trial in five steps: baseline the old oil, sample the new fill, then fix sampling interval, tests and stop limits before results.
-
Moving a plant to fully synthetic gear oil: the risks to weigh
Switch a plant to synthetic gear oil only after seal, paint, residual-oil, warranty and payback checks pass; otherwise switch gearbox by gearbox.
-
Why a PTSA tracer reads low when the chemical pump is dosing
A low PTSA tracer reading with a running pump usually means product is not reaching the tower, blowdown rose, or the fluorometer reading is suppressed.
-
Cooling tower conductivity: controller vs handheld meter readings
A cooling tower controller and handheld meter disagree from probe fouling, calibration drift or temperature compensation. How to tell which is right.
-
Why white rust comes back after cooling tower passivation
White rust that returns after passivation usually means the first passivation was incomplete or pH, alkalinity or hardness drifted. Tell which, and act.
-
Why fish eyes in coating keep coming back after line cleaning
Fish eyes that return after a coating line cleanup usually come from compressed air, supply air, a new coating lot or nearby silicone. Tell them apart.
-
Why powder coating adhesion failures hit only some batches
Powder coating adhesion that fails on some batches only points to a shared factor: substrate lot, pretreatment bath, oven or shift. How to find it.
-
Switching to a non-etching aluminum cleaner: what to check first
Before switching to a non-etching aluminum cleaner, check pH, temperature, concentration and inhibitor for the alloy, then trial etch, smut, water-break.
-
Causes of a powdery zinc phosphate coating on steel parts
Powdery zinc phosphate usually comes from poor rinsing, excess sludge, too much accelerator or an off-temperature bath. Bath titrations show which one.
-
Why stainless steel parts discolor after passivation
Discolored stainless after passivation usually means poor precleaning, embedded iron, a high-sulfur grade or a bad bath. How to tell them apart on site.
Talk to us about your sales team.
Custom plans, custom terms, security reviews and onboarding across teams or branches. Tell us a little about your organization and we will reply with a starting plan.
Contact Sales- 01Start from site data and your documents
Bring in the TDSs, test reports and site records your team already has. Where a case has too little to go on, the agent searches the web for public sources such as manufacturer data and standards.
- 02State the case
Describe the customer's situation in plain words. The agent reads the site's conditions and history, proposes the task that fits, and starts when you say go.
- 03Review the reasoning, step by step
Each step shows what was considered, what the evidence supports and what was ruled out, with the source behind each point. You can carry on, ask for changes or stop.
- 04One document for this customer
The case ends in a document built for that customer: the conclusion, the reasoning, the conditions it depends on and what to do next. Share it through Field Care when you choose.